Chapter 4 Installation
24
Step 1 Set Switches and Jumpers,
Continued
J6 Select Flash EPROM Voltage
J6 is a three-pin berg that selects voltage level supplied to the Flash EPROM.
J6 Pin Settings
LED selected
Short Pins 1-2
5 volts
Short Pins 2-3
12 volts (Factory setting)
P24 Unused
P24 is not used.
Step 2 Install System Memory
The main memory subsystem on the Excalibur PCI motherboard consists of six 32-bit memory sockets. Each bank of
memory consists of two sockets. Either two, four, or six SIMMs must be installed; the memory banks are always non-
interleaved.
One x 36 SIMM package is the equivalent of four x 9 SIMM packages. You can use 256 KB x 36, 512 KB x 36, 1
MB x 36, 2 MB x 36, 4 MB x 36, or 8 MB x 36 bit SIMMs. The Excalibur PCI motherboard uses fast page mode SIMMs
operating at 70 ns (RAS access time).
Содержание Excalibur PCI
