Amcrest AMDVTENL8, Руководство пользователя

Страница: 157 / 199

157
Anti-dither This field allows the user to set the anti-dither time. The values in this field can
range from 5 to 600 seconds. This time value controls how long the alarm signal
lasts. Based on motion detection, a buzzer can go off, a tour can begin, PTZ can be
activated, a snapshot can be taken, or a channel can begin recording.
For example, if the anti-dither time is set to 10 seconds, each alarm may
last 10 seconds if the local alarm is activated. During the process, if the
system detects another local alarm signal at the fifth second, the buzzer,
tour, PTZ activation, snapshot, record channel functions will begin
another 10 seconds while the screen prompt, alarm upload, email will not
be activated again. After 10 seconds, if system detects another alarm
signal, it can generate a new alarm since the anti-dither time has expired.
Region The setup button takes the user to the motion detection region setup screen for
that specific channel.
•
When the setup button is clicked, the current channel’s interface comes
into a full screen view. The user can then set up to 4 regions, each with
their own region name, sensitivity (1-100), and threshold (1-100). Each
region has a specific color, and the region selector tool is displayed when
the mouse is moved to the top of the screen.
o
Sensitivity is the amount of change required to increase the
motion detected by a percentage. The lower the sensitivity, the
more movement is required to trigger an alarm.
o
Threshold is the level that the motion detection needs to reach
in order to trigger an alarm. The lower the threshold, the more
likely that motion will trigger an alarm.
•
To designate a zone, click and drag the mouse over the area desired.
When a colored box is displayed over the live feed, that area is now
enabled for motion detection. Clicking the FN button will switch the mode
between armed and disarmed, so that clicking and dragging the mouse
can either designate a motion detection zone, or remove any motion
detection zone markers.
•
After the motion detection zone is set, click the enter button to exit the
motion detection screen. Remember to click the save button on the
motion detection settings screen, otherwise the motion detection zones
will not go into effect. Clicking the escape button to leave the motion
detection zone and will not save the zone setup.
Record
Channel This checkbox allows the user to enable the system to record video for that
channel when a motion detection alarm is triggered.
Record Delay This field specifies in seconds how long the delay between alarm activation and
PTZ activation should be.
PTZ Activation This checkbox allows the user to enable the system to activate PTZ movement
when a motion detection alarm is triggered. To setup the PTZ activation settings,
click the setup button next to PTZ activation.
On the PTZ Activation screen, each camera can be setup to perform a preset
PTZ action based upon motion detection.
Tour This checkbox allows the user to enable the system to cause a PTZ tour to occur
when a motion detection alarm is triggered. Multiple cameras can be specified to
perform a tour.