AMCI ANS1 ANYNET-I/O, Руководство пользователя

Страница: 69 / 90

20 Gear Drive, Plymouth Ind. Park, Terryville, CT 06786

Tel: (860) 585-1254 Fax: (860) 584-1973 http://www.amci.com
Output Data Format
5
69
Command Block 10: Program Production Cycle Parameters
This block allows you to program the Production Cycle parameters, which affect the part counters available
on the ANS1.
Figure 5.13 Command Block 10
Command Word Bits
Bit 8: Program Production Cycle Increment Position Parameter.
If this bit is reset to ‘0’ the Production
Cycle Increment Position parameter is left at its previous value. If this bit is set to ‘1’, the Production
Cycle Increment Position parameter is set to the value contained in word 1.
Bit 9: Program Production Cycle Multiplier / Divisor Parameters.
If this bit is reset to ‘0’ the Production
Cycle Multiplier and Production Cycle Divisor parameters are left at their previous values. If this bit
is set to ‘1’, the Production Cycle Multiplier parameter is set to the value contained in word 2 and the
Production Cycle Divisor parameter is set to the value contained in word 3.
EtherNet/IP
Address
Modbus
Address
Bit Number
15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
0 1024
T
ransmit Bi
t
0 0 0 0 0
Ap
ply
W
o
rd
s
2&
3
Apply W
o
rd 1
0 0 0
Clear Error
1 0 1 0
1 1025
Production Cycle Increment Position
(Range of 0 to ( Full Scale Count -1))
2 1026
Production Cycle Multiplier
(Range of 1 to 32,767)
3 1027
Production Cycle Divisor
(Range of 1 to 32,767)
4 - 19 1028-1043 Not Used