Amazone UG 2200 Special, Руководство по эксплуатации

Страница: 138 / 252

Commissioning
7.2 Adjusting the length of the PTO shaft to the tractor
WARNING
Danger from
•
damaged and/or destroyed, flying parts for the operator /
third party if the PTO shaft is compressed or pulls apart
while the machine coupled to the tractor is being
raised/lowered, because the length of the PTO shaft has not
been adjusted properly.
•
being caught and drawn in if the PTO shaft is installed in-
correctly or if unauthorised design changes are made.
Have the length of the PTO shaft checked in all operating positions by
a specialist workshop and, if necessary, adjusted before coupling the
PTO shaft to your tractor for the first time.
Always observe the operating manual supplied with the PTO shaft
when adjusting the PTO shaft.
This adjustment of the PTO shaft applies only for the current tractor
type. You may need to readjust the PTO shaft if you couple the ma-
chine to another tractor.
WARNING
Risk of being caught and drawn in if the PTO shaft is installed
incorrectly or if unauthorised design changes are made.
Only a specialist workshop may make design changes to the PTO
shaft. When doing so, read and follow the operating manual from the
manufacturer.
Adjusting the length of the PTO shaft is permitted with consideration
of the minimum profile overlap.
Design changes to the PTO shaft that are not described in the operat-
ing manual from the PTO shaft manufacturer are not permitted.
WARNING
Risk of crushing between the rear of the tractor and the machine
when raising and lowering the machine to determine the short-
est and longest operating position of the PTO shaft.
Only actuate the operator controls for the tractor's three-point linkage
•
from the intended workstation.
•
if you are outside of the danger area between the tractor and the
machine.
138 BAG0021.14 05.19