6.2.7 Coupling the electric supply lines
Depending on the implement controls, the plug for
the electrical supply on the conveyor line can look
different.
1.
In conjunction with integrated implement
controls,
insert the plug
1
on the interface
2
or
In conjunction with autonomous implement
controls,
insert the plug on the interface or on the front
3-point power lift.
2.
Route the ISOBUS cable with sufficient freedom
of movement and without chafing or pinching
points.
1
2
CMS-I-00003623
6.3 Preparing the implement for operation
6.3.1 Adjusting the working position sensor
The working position sensor monitors the implement
position in the three-point hydraulic system and
switches the metering drives. The length of the
actuation lever is adjustable. For safe actuation, the
control lever must rest on a level contact surface.
1.
loosen the nut
1
.
2.
To rest the control lever
2
on a level contact
surface,
set the position of the control lever in the desired
position on the top link
3
.
3.
Tighten the nut.
4.
To configure the working position sensor,
refer to the ISOBUS operating manual,
"Configuring the working position sensor".
1
2
3
CMS-I-00002608
CMS-T-00005069-B.1
CMS-T-00003202-F.1
CMS-T-00003625-B.1
6 | Preparing the machine
Preparing the implement for operation
MG6492-EN-II | G.1 | 26.04.2021
52
