6.3.8 Adjusting the throughput of the disc gangs
The disc gangs can be set to high throughput
A
or
low throughput
B
:
If the disc gangs are set to high throughput, the
tines can work at a depth of 14.5 cm with the disc
gangs fully lifted, without the discs penetrating the
soil. If the tines work at a depth of 30 cm, the
discs are working at a depth of 15 cm.
If the disc gangs are set to low throughput, the
tines can work at a depth of 22.5 cm with the disc
gangs fully lifted, without the discs penetrating the
soil. If the tines work at a depth of 30 cm, the
discs are working at a depth of 7,5 cm.
High throughput is pre-set at the factory, and must be
selected under the following conditions:
High amount of organic matter
High amounts of crop residues
If the discs are used at the maximum working
depth
Low throughput must be selected under the following
conditions:
If the pulling force requirement should be reduced
at the maximum working depth
Under wet conditions and high working depth of
the tine array
When the tines should work deep, but not with the
discs
A
A
B
CMS-I-00004871
1.
To change the disc gangs from high throughput
to low throughput:
Lower the running gear into transport position.
2.
Set the working depth of the disc gangs to the
smallest value using the "green 3" tractor control
unit.
3.
Secure each disc gang with suitable lifting gear
and slings against lowering.
4.
Unscrew the nuts
1
on all of the bearing plates
3
of the disc gangs and remove them along with
the wedge lock washers
2
.
1
2
1
3
3
3
CMS-I-00004879
CMS-T-00006961-C.1
6 | Preparing the machine
Preparing the implement for operation
MG7242-EN-GB | L.1 | 26.07.2022 | © AMAZONE
59
