10.1.2 Replacing the discs
INTERVAL
as required
REQUIREMENTS
The wear limit specified in the technical data
has been reached.
1.
Slightly raise the implement.
2.
Loosen the 4 bolts
1
for the disc fastening.
3.
Remove the washer
2
.
4.
Fasten the new disc with the 4 bolts.
1
2
CMS-I-00002450
10.1.3 Aligning the disc gangs relative to each other
INTERVAL
as required
The disc gangs are aligned relative to each other
using adjustment spindles. The adjustment spindles
are attached between the disc gangs.
The alignment of the disc gangs is suitable for the
following:
Optimising the working depth of the disc gangs
relative to each other
Correcting lateral pull of the implement
Preventing uneven wear of the discs
1.
Align the unfolded implement horizontally.
2.
Set the working depth of the disc gangs to the
smallest value.
The discs are not standing on the ground.
3.
Loosen the lock nuts
1
on all of the adjustment
spindles.
4.
Align the disc gangs using the hexagonal profile
2
on the adjustment spindle.
1
2
CMS-I-00003204
CMS-T-00002327-C.1
CMS-T-00004786-A.1
10 | Repairing the machine
Maintaining the machine
MG6158-EN-II | H.1 | 30.04.2021
63
