Amada MF-C2000A Series, Руководство по эксплуатации, Страница: 173 / 272

3 . Initial Settings
173
MF-C2000A Series
Chapter 5 Laser Processing by External Communication Control (RS-485 CONTROL)
Introduction Part
Operating Part
Maintenance Part
Appendixes
Installation
and
Preparation
Part
3 . Initial Settings
Perform initial settings to control laser processing by external communication
(RS-485 CONTROL) . Set communication schedules and equipment No . on the
laser controller .
The communication schedules for data transfer are as follows.
Data transfer system Conforming to RS-485, asynchronous, full duplex
Transfer rate 9600, 19200, 38400, 57600, 115200 bps
Data type Start bit 1
Data bit 8 or 7
Stop bit 2 or 1
Parity bit Even/odd/none
Character code ASCII
⇒
Set the transfer rate, data type, and equipment No. by displaying the RS-485
COMMUNICATION SETUP from the CONFIG screen by the laser controller of
each equipment that is connected to the personal computer, etc.
Setting Communication Schedules and Equipment No .
Set the communication schedules and equipment No . by displaying the RS-485
COMMUNICATION SETUP from the CONFIG screen by the laser controller of
the equipment .
1
Displaying the CONFIG Screen
(1) Press the "CONFIG" button to display the CONFIG screen.
(2) Press the "RS-485 COMM" button.
The RS-485 COMMUNICATION SETUP is displayed.