Alutech CUID-400N, Руководство по сборке и эксплуатации

Страница: 51 / 64

БЛОК УПРАВЛЕНИЯ CUID-400N | БЛОК УПРАВЛІННЯ CUID-400N | CONTROL UNIT CUID-400N
49
ADjUSTMENT
TX RX
NC NO
COM
- + - +
X11
PH.T PH1 SE +24V +12V S CL OP
Figure 4. Photocells connection
TX RX
NC NO COM
- - +
X11
PH.T PH1 SE +24V +12V S CL OP
+
TX RX
NC NO COM
- - +
X11
PH.T PH1 SE +24V +12V S CL OP
+
TEST
A B
Figure 5. Photocells connection to perform automatic test of their operation (
Phototest
):
A —photocells with typical connection,
B
—photocells with special output
TEST
6. ADjUSTMENT
The operation parameters are set using the display and control unit module buttons. To enter
the operation parameters set-up mode, press and hold the button ‘ F ’ on the control module
for at least 3 seconds ( fig. 2). Select the necessary settings ( table 7) using the ‘
F
’ button. The
selection of the required parameter value is performed by pressing or holding buttons ‘ + ’ or ‘ − ’
on the control unit module. Press button ‘ F ’ to confirm the selected value. Press and hold the
button ‘
F
’ for at least 3 seconds to exit the operation parameters set-up mode, in this case all
the selected values will be saved. All control commands for the door movement are ignored in
the operation parameters set-up mode.
To return to the initial settings of the control unit module (default settings) enter the operation
parameters set-up mode (‘ ’on the indication display), press and hold the button ‘ CL ’ for at
least 3 seconds on the control unit module ( fig. 2). Short-term indication ‘ ’ on the display
means deletion of all previously set values and return to the default values.