DISASSEMBLING AND CLEANING THE FAN
(FOR HEAVY GRIME BUILD-UP)
When there is a build-up of heavy grime or grease, the fan must be
removed for a thorough cleaning. Take the following steps.
➪
Switch the unit off at the main power switch.
➪
Remove the shelf racks. Remove the side rack shelf supports.
➪
Open the suction panel by unscrewing the two screws, and
swing the panel open.
➪
Holding the fan wheel, screw off the ball-shaped water diffuser
using the special wrench supplied with the unit.
➪
Loosen the two socket hexagon bolts (diagonally opposite) with
the same wrench.
➪
Screw the special wrench onto the hub of the fan wheel until the
wheel "pops" out from the shaft.
➪
Spray fan, ball-shaped water diffuser and pipes with the
cleaning agent and let work for approximately 5 minutes.
➪
Afterward, rinse well with the hand spray.
RE-ASSEMBLING THE FAN
➪
Clean the motor shaft on the inside of the oven.
➪
Set the fan wheel back on the motor shaft and tap lightly into
place.
➪
Screw on the ball-shaped water diffuser tightly.
➪
Screw in tightly the two socket hexagon bolts (diagonally
opposite) with the special wrench.
➪
Replace the shelf racks and suction panel. Replace the shelf
base and secure.
➪
Switch unit ON.
CLEANING THE WATER CONNECTION
There is a filter screen in the
water connection to prevent the
water inlet from becoming
blocked.
Clean this screen as follows:
➪
Turn over power switch to the OFF position.
➪
Disconnect the water connection located underneath the unit.
➪
Remove and clean the filterscreen.
➪
Replace the filter and re-connect the water.
➪
Switch the unit ON and check for water leakage.
CLEANING THE DRAIN PIPE
The unit comes with a drain trap built-in underneath
the unit as standard equipment.
To clean or unblock the drain trap, take the
following steps.
➪
Turn oven power switch to the OFF position.
➪
Using a wrench, remove the drain plug.
➪
Clean out deposits that accumulate in the trap.
➪
Rinse out the open drain with the hand-held hose.
➪
Replace the drain plug.
➪
Switch the unit ON and check for water leakage.
CLEANING FLUE OUTLET
The exhaust outlet of the oven at all circumstances should be kept
clear of objects that could obstruct the flow of combustion gases.
➪
Inspect the flue diverter assembly, located on top of the unit.
➪
Remove debris and dirt that may have accumulated.
Operation and Care Manual #6011 • 19
M a i n t e n a n c e • S e c t i o n 3
