Altendorf WA 6, Руководство по эксплуатации

Страница: 43 / 76

Installation
43
0000010064-007- GB
Installation
6.4.6 Angle cut
Before checking the angle cut, check the settings of the sliding table (see oper
-
ating instructions) and of the swinging arm, and correct them if necessary.
The cross-slide is clamped to positions of approx. 300 mm and 1300 mm from
the sliding table end. In these two positions, the angle cut is checked and ad
-
justed as described above. Ensure that the setting does not exceed the maxi
-
mum permissible tolerance of < 0.2 mm (for the 5th cut (dimension 1 -
dimension 2)).
After checking the angle cut, move the crosscut fence to position 2. Repeat the
checking and adjustment process, turn the board clockwise during this pro
-
cess.
Checking the angle cut
• Set the saw blade to the maximum cutting height
• Position a board of approx. 1000 x 1000 mm (preferably
MDF) on the rip fence and cut off a narrow piece
• Follow steps 1 - 5 (as shown in the figure)
• The 5th step generates a strip which should have a width
of approx. 10 mm
• Measure the thickness at both ends of the strip with a
vernier calliper
• Divide the difference of the two dimensions by 4 to cal
-
culate the angular error per metre of cut length
• Ensure that the difference of the two dimensions does
not exceed 0.2 mm
• Repeat the angular cut check on the 2nd position of the
sliding table
Angular cut setting
• Undo the lock nut (1)
• Adjust the threaded pin (2)
• Tighten the lock nut (1)