Allmand Maxi-Air MA375-DP T4F, Руководство оператора

Страница: 65 / 88

Not for
Reproduction
65
Maintenance
5-13
Clean element in sedimenter
Every 500 hours
1.
Turn the fuel selector valve
[A]
to the
[
OFF
]
position.
2. Loosen the drain valve [B] and drain out condensed water
inside.
3. Turn the cup
[C]
to the left and remove it. Wipe out the
inside of the cup.
4. Remove the float
[D]
inside the cup
[C]
.
5. Wash the element
[E]
and the inside of the cup
[C]
with
new fuel.
6. Inspect the element
[E]
and O-ring (
[F]
&
[G]) for wear or
damage. Replace if needed . (For part number, See
“Replacement Parts.”)
7. Assemble in the reverse procedure.

If air remains in the fuel line, set the CONTROL POWER
switch to
position and release the air by loosening
the bolt [H].

Drain the condensate into a container
[I]
, then dispose of
the condensate according to the designated regulations.
Check for cracks and leaks on the exhaust pipe
Every 500 hours
 Inspect the flexible pipes in the exhaust system for
cracks or leaks etc.

Remove any insulating material wrapped around
pipes when performing inspection.
 If any leak is found, take care to avoid getting
burned by exhaust gas.
 After finishing inspection, rewrap the insulation and
tighten with with a clamp or belt.
A160708-1
A H
G
F
E
C
D
B
I
ON
OFF
Loosen
A180279
Exhaust flexible pipe
Heat insulator Crack
Gas leak
DPF