Allmand Maxi-Air MA375-DP T4F, Руководство оператора

Страница: 5 / 88

Not for
Reproduction
5
WARNING
Contact with the output terminals and control board
could cause electric shock, resulting in death or
serious injury. Do not open the cover of the output
terminal board during machine operation.
When removing or connecting a connecting cable
for changing load, be sure to switch OFF the circuit
breaker, remove the starter key from the starter
switch, then perform work.
WARNING Contact with rotating parts or
could cause death or serious injury. Keep hands
while machine is in
WARNING Do not open radiator
after operation. Explosive
could cause severe burns,
WARNING Do not touch hot parts.
Never work nearby hot portions of the machine while
it is running.
Parts such as engine, exhaust manifold, exhaust
pipe, muffler and radiator are especially hot. Never
touch these parts, as it could result in serious burns.
Coolant water and engine oil are also very hot and
dangerous to touch. Do not check or add while
machine is running.
WARNING Fire prevention.
Fuel and oils are extremely flammable. Do not bring
ignition sorces near machine when checking or
adding fuel and oils.
Adding fuel and oils should be done outdoors or in a
well-ventilated location.
Refuel after stopping engine, and never leave
fuel near machine. Do not spill. If spilled, wipe up
completely.
Do not fill fuel oil up to cap level. Fuel oil will overflow
due to volume expansion caused by rise of ambient
temperature. Fuel can also spill during machine
movement or transporting.
Parts such as muffler and exhaust pipe can be
extremely hot. Remove twigs, dried leaves, dried
grass, waste paper, etc. from around muffler and
exhaust pipe.
Keep a fire extinguisher available by machine in case
of fire.
WARNING Hang a “Now Checking and under
tag:
Remove starter key from starter switch before
starting inspection, and hang up a “Now Checking
and under Maintenance” tag where it can be easily
Operator Safety
S-2
Please indicate the MODEL / SER.No. on the plate of the machine when making inquiries.
A plate stamped with the model and serial number is attached to
the side of the machine.
Each illustrated figure (Fig.) has a number
(for instance, A130375) at the right bottom.
This number is not a part number, but it is used only for
our reference number.
A130375
A VIN plate is also located on the left side of the machine.