Allmand Maxi-Air MA375-DP T4F, Руководство оператора

Страница: 62 / 88

Not for
Reproduction
62 ALLMAND.COM
Maintenance
5-10
Change compressor oil
At 300 hours for the first change and at every 500 hours thereafter
 Compressor oil should be changed according to the interval called out in the Maintenance Chart.
Under harsh operating conditions, it should be changed more often.
 Failure to change compressor oil according to the Maintenance Chart could result in a fire, or in damage
to the compressor components.

Change compressor oil only after the machine is shut down, the components have cooled, and the
pressure in the separator receiver tank has dropped to zero (0).
1. Remove the oil filler cap [A] and open the drain valve [B]
to drain the residual oil.
2. Remove the oil cooler drain plug [D] and open the drain
valve [E] to drain the oil accumulated in the cooler.
3. After draining compressor oil, tighten drain valves [B] and
[E].
4. Fill the tank with new compressor oil up to the height
indicated by the dotted line (Limit).
5. Inspect the O-ring [C] of the filler cap [A] for hardening or
damage. Replace if needed. Then install the oil filler cap
[A].
6. After starting operation, check and confirm that the oil
level is between the red lines on the oil level gauge.
7. Repeat Steps 1 through 5 if the oil level is above or below
the red lines.

Avoid mixing different brands of compressor oil. Mixing different brands of compressor
oil could cause an increase in viscosity and make compressor oil sticky, resulting in
sticking of the compressor air-end. If compressor oil brands are mixed, the compressor
air-end must be cleaned. Contact your dealer.

Follow the designated regulations to dispose of compressor oil.
CLOSE OPEN
A180277
Quantity of oil between the red lines
Approx.5L
Quantity of change oil
Approx.40L
A
C
B
E D
Red
lines
Drain
container
Limit