Instructions
A. For tyres of cars,
motorcycles, etc:
1. Plug the cigarette lighter
into car 12vDC socket.
2. Screw the valve connector
clockwise onto the tyre valve
stem. Make sure the
connection is well made.
3. Set the target pressure
value (please refer to: How
to Use Digital Gauge).
4. Press On/Off, the device
starts to work.
5. The device will stop
working automatically when
reaching the preset value.
6. Release On/Off.
7. Remove and store the air
hose in the storage
compartment provided.
B. For air mattress, footballs,
children play raft, etc:
1. Select the proper adapter and insert
into the Connector.
2. Insert the connected adapter into the
appropriate receiver on the inflatable.
3. Follow the same steps as instruction A.
4. Check for proper firmness and adjust as
needed.
5. Remove the adapter from the
Connector.
C. The LED light has 3
functions:
1. Turn the knob to LIGHT, the light is for
illuminating a work area.
2. Turn the knob to FLASH, this function is
to alert other road users to a potential
hazard.
3. Turn the knob to SOS, the light will flash
the SOS distress signal.
LED Lights
Digital Tyre
Guage
Stem
ON/OFF
Lights
Switch
Air
Hose
Portable Tyre Air Compressor User Manual
Adaptor for
sports ball
Adaptor for air
mattress and raft
Cigarette Lighter
Connector
M
(1) Switch units of pressure among Bar,
KPA and Psi.
(2) Release the gauge from measuring status to
reading status.
Instruction
1. Presetting the target value
(1) Hold + or - for more than 5 seconds
until LCD display flashes. This figure is the
previous pre-set value (default: 30Psi).
Press + or - until the value is set to the
new target pressure level, and wait 2-3
seconds. The LCD will display the current
pressure value.
(2) Press M, the LCD displays "ON" this
indicates the device is ready to start working.
+
Increase preset pressure.
-
Decrease preset pressure .
ON/OFF
Switch off the device
How to Use Digital Gauge
2. Inflating:
Press ON/OFF, the device starts to work until
the target pressure is reached. The device
automatically switches off and LCD displays
"OFF".
Note: In case of emergency the device can be
manually switched off during use.
3. Inflating other items:
(1) If other items require a different pressure
value, repeat the steps mentioned above.
(2) If other items require the same pressure
value as has already been preset, press M and
then ON/OFF, and the device works again.
