6
Features in sb275a04
Software Maintenance Release Note
Version sb275a05
C613-10464-00 Rev H
Features in sb275a04
Software maintenance version sb275a04 includes all resolved issues and
enhancements in earlier 2.7.5A versions, and the resolved issues and
enhancements in the following tables.
Level 1
No level one issues
Level 2
CR
Module
Level
Description
CR00007522
CR00012896
IP Gateway
2
The switch’s hardware IP route table occasionally did not contain the most
optimal route to a destination. This meant packets were sometimes sent
via sub-optimal routes. An additional effect was that when multiple equal-
cost routes existed a less than complete set of those routes would be
utilised.
This issue has been resolved, so that the switch forwards packets via the
best IP route(s) available.
CR00009026
IP Gateway,
OSPF
2
The IP route cache (and therefore the Layer 3 IP routing table in hardware)
was sometimes refreshed unnecessarily when OSPF SPF recalculation took
place as a result of OSPF receiving a router LSA update.
This issue has been resolved.
CR00009347
GUI
2
It was not possible to use the GUI to add untagged ports to the default
VLAN.
This issue has been resolved.
CR00009826
IP Gateway
2
When a static ARP is deleted, the switch sends out an ARP request to
attempt to create a dynamic ARP for that IP address. Previously, the switch
did not process the ARP response correctly and therefore did not add the
ARP to its ARP table.
This issue has been resolved. When a static ARP is deleted, the switch
attempts to create a dynamic ARP for that IP address, and will successfully
add it to the ARP table if a device responds.
CR00010170
OSPF
2
Route maps did not filter static routes of external type 2 when
redistributing them into OSPF.
This issue has been resolved.
CR00010598
OSPF
2
When filtering OSPF routes, IP route filters did not filter out intra-area
interface routes.
This issue has been resolved.
CR00010827
OSPF
2
Previously, OSPF would advertise LSU packets to the wrong area when a
stub area was altered.
This issue has been resolved.
CR00011219
IPv4
2
When the switch received an IP packet with invalid IP option length (a
corrupted packet), a reboot might occur.
This issue has been resolved.
