Software Version sb275a05
9
Version sb275a05
C613-10464-00 Rev H
Level 4
CR00013048
Firewall
3
When IP NAT or firewall NAT was used, the switch sometimes generated
ICMP messages that specified the wrong source IP address. This meant
that the response to traceroute could be incorrect.
This issue has been resolved.
CR00014021
Switch
3
In certain circumstances, if the switch was configured with IP filters and
STP, then some traffic would be incorrectly blocked.
This issue has been resolved.
CR
Module
Level
Description
CR
Module
Level
Description
CR00002394
IP Gateway
4
RIP would try to send route update packets when the lower link layer was
down.
This issue has been resolved, so that RIP no longer tries to send packets
when the lower link layer is down.
CR00008006
OSPF
4
Previously, the maximum metric value for OSPF route redistribution was
16777215. This has been changed to 16777214.
CR00010399
IP Gateway
4
Previously, the ? help for some IP commands showed duplicate options.
This issue has been resolved.
CR00010540
TTY
4
Sometimes, output from the CLI ? help is long enough for the page
scrolling mechanism to take effect. This produces the prompt:
--More-- (<space> = next page, <CR> = one line, C = continuous, Q = quit)
Previously, if a user entered q in response to this prompt, the command
was lost instead of regenerated.
Also, commands terminated with the ? or Tab characters were added to
the command history with the ? or Tab character present, which is not
desirable behaviour.
These issues have been resolved.
CR00010584
OSPF
4
The “operation successful” message was not produced after the
command
reset ospf spf
was successfully carried out.
This issue has been resolved.
CR00011743
Core, GUI
4
The GUI sometimes displayed a value above 100% for the peak utilisation
of a port.
This issue has been resolved.
CR00012192
Core, Utility
4
If the ? is entered at the end of an incomplete command (to obtain help),
but the partially-entered command contains an error, then an error
message is displayed.
Previously, the incomplete command was not then re-presented to the
user for editing.
This issue has been resolved, so that the incomplete command is now
presented to the user again after the error message.
