Allied Telesis SwitchBlade 4000 Series, Руководство по выпуску

Страница: 8 / 22

8 Features in sb275a04 Software Maintenance Release Note
Version sb275a05
C613-10464-00 Rev H
Level 3
CR Module Level Description
CR00000133
CR00008167
Log 3 Messages in the permanent log were lost after changing the queue length
for the permanent log.
This issue has been resolved.
CR00002589
CR00011829
IPX 3 Previously, an IPX circuit sometimes incorrectly displayed its link status as
UP, when it was actually in a DOWN state.
This issue has been resolved.
CR00009817 Ping 3 The command purge ping totally did not purge all the information
about ping polling.
This issue has been resolved.
CR00010183
OSPF 3 If a route had already been learnt by OSPF, and then the inroutemap on
OSPF was configured in such a way that the properties of this route should
be altered as it is imported into the IP route table, the route would not be
altered even if the SPF calculation was repeated.
This issue has been resolved.
CR00010184 OSPF 3 If route map filtering altered the type of a AS-External route, the metric
format was not also appropriately altered.
This issue has been resolved, so that the metric format will also be altered
to be appropriate for the route type.
CR00011652 GUI 3 It was not possible to use the GUI to edit a file (through the Management
> Configuration Files > Edit page) if the filename contained a hyphen
(such as test-1.cfg). The browser returned a “page not found” error.
This issue has been resolved. You can now edit such files.
CR00012130
IP Gateway 3 The command set ip route preference= value protocol= protocol did
not correctly update the preference of all routes learned by the specified
protocol.
This issue has been resolved.
CR00012427
CR00002887
Logging 3 If a user modified the permanent log by destroying it and creating a new
one, and then saved the configuration with the command
create config ,
the resulting configuration file included the command destroy log
output=permanent . Therefore when the switch restarted it destroyed
the log and all entries.
This issue has been resolved. The command create config now writes the
command set log output=permanent to the configuration file instead
of the destroy and create commands.
CR00012947
Log 3 When a user entered the command show log receive= ipadd
mask= mask , the switch displayed an error message that said mask was
not a valid parameter.
This issue has been resolved. The mask parameter is now valid for this
command.