18
Features in sb275a01
Software Maintenance Release Note
Version sb275a05
C613-10464-00 Rev H
Level 3
Level 4
Enhancements
CR
Module
Level
Description
CR00007863
IPv4 ICMP
3
Previously, SwitchBlade v2 linecards did not generate an ICMP redirect
message in response to the first ICMP request they received.
This issue has been resolved.
CR00011316
Operations
3
Previously, entering the command
set summertime
could cause extra
digits to appear in the output of the commands
show ip interface
and
show config dynam=trigger
.
This issue has been resolved.
CR00011339
Port Trunking
3
The command
create switch trunk
appeared twice in the configuration
file created by the command
create config
—in both the switch pre-VLAN
and post-VLAN sections.
This issue has been resolved, so that the command now only appears in
the post-VLAN section.
CR00011480
DHCPv4 Server
3
BOOTP Relay and the DHCP server cannot operate at the same time.
Previously, if an attempt was made to enable one of these services and the
other service was already operational, the second service was made
operational. The first service stopped operating, but the switch did not
report this.
Now, the switch reports an error instead of enabling the second service.
CR
Module
Level
Description
CR00011127
SYSLOG
4
System log messages of type “switch” are now indicated by the number
3 and the text “SWI”, as shown in bold in the following example:
09 10:27:05
3
SWCX
SWI
SILIC Soft reset on Port 2.3
CR00011184
HealthCheck
4
The command
show switch loopdetection
now shows all ports in both
the LDF Method and BCCOUNTER Method sections of the output.
Previously, the BCCOUNTER Method section only showed the ports for
which
loop=bcc
was enabled.
CR00011651
Board
Hotswap
4
When the command
reset switch blade
was entered with a blade
number that was too high, the error message sometimes said that the
maximum blade value was 10.
The error message now correctly says that the maximum blade value is 8.
CR
Module
Level
Description
CR00011621
SYSR
-
The
show sys sysr slave
command now shows the slave switch
controller’s synchronisation status and the last event that occurred on the
slave controller. This information is updated every 5 seconds.
