10
Features in sb275a04
Software Maintenance Release Note
Version sb275a05
C613-10464-00 Rev H
CR00012774
IP Gateway,
TCP
4
In an unusual network configuration where the IP subnet on one interface
was a subset of that on another interface, it was possible for the results
of a trace route to show erroneous information.
This issue has been resolved. A search for an interface using an address
within the interface's subnet now finds the most specific match for the
address.
CR00012946
Log
4
When a user entered the command
show log receive=
ipadd
,
information about all IP addresses was displayed unless the user also
entered the
mask
parameter.
This issue has been resolved. Specifying an IP address without a mask now
limits the display to information about that IP address.
CR00013332
Core
4
When insufficient arguments were entered in the command
set
interface
, an error message was not produced.
This issue has been resolved, so that an error message is now correctly
output.
CR00013334
TCP
4
The
delete tcp
command did not output a success message after
successfully completing.
The
enable tcp debug
command produced messages with the wrong
module ID.
These issues have been resolved.
CR00013336
Core, NVS, TCP,
TTY
4
If parameters were incorrectly entered twice in some
set
or
show
commands, the resulting error message was corrupted and included
meaningless characters.
This issue has been resolved.
CR00013442
Switch
4
When the user attempted to enable CPU Tx health checking on an
instance in the SwitchBlade controller (by using the command
enable
switch healthcheck=cputx
), the switch correctly rejected this command.
However, the output of the
show config dynamic
or
create config
commands included this rejected command.
This issue has been resolved.
CR
Module
Level
Description
