© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
9
202065R6
Washer Operation
Start Up
When power is applied to the washer, the control will
display its software version as “
S XX
” (“
XX
” is the
version number) for one second. The control will enter
different Modes depending on the Mode it was in at
power down.
Ready Mode
To start the cycle, the user must press the START
keypad.
The user will be able to select a different cycle or wash
water temperature by pressing a cycle pad when the
machine is in the Ready Mode or in the first fill cycle.
(If certain types of card readers are connected to the
machine, the cycle can’t be changed after START is
pressed.) If not enough vend is entered to satisfy the
vend price, the control will display the remaining vend
price needed to start the cycle. If the first fill was
interrupted to change temperature or cycle type that
requires more money, and the vend price is not
satisfied within 1 minute, the washer control will go
back to the first selection and the cycle will continue.
After the first fill, all key presses will be ignored,
allowing the washer to go through the complete cycle.
When a cycle is complete, the control will display “
00”
until the lid is opened, a key is pressed, or a coin/card is
entered. When one of these three options occur, the display
will revert back to the Ready Mode.
Cycle Sequence
Upon the start of a cycle, the control will display the
total cycle time. The appropriate LEDs will light while
the machine passes through different cycle steps. Any
coin entered after the first fill step will be added to the
total coin counter, but the user will not be able to
change cycles or water temperature. If coins are
entered in the last three minutes of a cycle, the current
cycle will end and the control will enter the Partial
Vend Mode.
Opening the Washer Lid
If the washer lid is opened anytime except the last three
minutes of a cycle, the display will show “
LId
” and the
timer will stop. Once the lid is closed, the cycle will
restart from the point of interruption. If the lid is opened
in the final three minutes of the final spin step, the timer
will continue to count down to the end of the cycle.
The cycle operation will stop and the display will
show “
LId
”. When the timer reaches 0 minutes, the
control will display “
00
” until a key is pressed, or a
coin/card is entered. When one of these options occur,
the display will revert to the Ready Mode.
