sequence etc., but not during the extract sequence. The error is
generated when the safety switch is switched more than 10 times
(for a short period of time) or for a period over 20 seconds.
Diagnosing Failure 3
1. Check if the safety switch is
broken. (Make sure shipping
braces are removed)
If the safety switch is broken:
replace the safety switch.
2. Check the position of the
safety switch.
If the safety switch is not cor-
rectly mounted: install the
safety switch properly.
3. Check the wiring, the con-
tact of the safety switch is
normally closed.
Check connector pins for
loose connections
If there is no continuity: repair
the wiring.
4. Check whether the washer is
not overloaded by the filled-in
linen
Do not exceed the specified
machine capacity.
5. Check the springs.
If damaged, replace them.
Table 54
Failure 4: The Linen is Not Correctly Distributed in
the Stage when the Machine Starts Up the
Spinning Sequence
This error occurs when the linen is incorrectly distributed in the
machine when it switches from distribution revolutions into high
revolutions or during the spinning sequence at low revolutions.
If the safety switch is activated, the machine first attempts five
times to redistribute the linen in the drum and carry out the spin-
ning sequence. If the safety switch gets activated 5 times, the
spinning sequence will be skipped. This function will protect the
machine against overload and assures the normal lifetime of the
washing machine.
Diagnosing Failure 4
1. Check the position of the
safety switch.
If the safety switch is not cor-
rectly mounted, install the out
of balance switch properly.
2. If this failure occurs often.
Use a fully loaded drum. A
completely filled drum produ-
ces less unbalance than a drum
that is only filled for 1/3.
Table 55
continues...
Diagnosing Failure 4
3. Check the wiring if there is
no bad connection.
The saftey switch is a NC
contact.
If there is a bad connection: re-
pair the wiring.
4. Check whether the washer is
not overloaded by the filled-in
linen.
Do not exceed the specified
machine capacity.
5. Check the springs.
Check the springs.
Table 55
Failure 5: Out of Balance High Spin
Failure 5 occurs when the out of balance sensor is activated dur-
ing high spin. This failure indicates that there will probably is a
mechanical defect.
Diagnosing Failure 5
1. Check the position of the
out of balance switch.
If the out of balance switch is
not correctly mounted, install
the out of balance switch prop-
erly.
2.Check the springs and the
other mechanical parts that fix
the drum.
If you see a broken mechanical
part: replace the broken part.
3. Check the wiring if there is
a bad connection.
If there is a bad connection: re-
pair the wiring.
4. Check that the washing ma-
chine is installed correctly and
stable.
Adjust the supports at the bot-
tom of the washing machine.
Table 56
Failure 6: Door Switch Failure
While a wash cycle is running the internal door lock systems are
scanned all the time. If during the wash cycle the wash computer
detects that the "DOOR SWITCH" is not closed then the machine
will immediately stop all its functions. The door will stay locked.
Diagnosing Failure 6
1. Check the well functioning
of the door switch. The door
switch is a normal open con-
tact.
If the door switch is broken or
malfunctions replace the door
switch.
2. Check the continuity of the
wiring.
If the wiring is not continuous:
repair the wiring.
Table 57
continues...
Troubleshooting
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
89
Part No. D1631ENR7
Содержание IYG065J
Страница 2: ......
