42
53264
Section 5 Service Procedures
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the dryer(s) before servicing.
• Close gas shut-off valve to gas dryer(s) before servicing.
• Never start the dryer(s) with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the dryer is properly grounded.
W001R1
WARNING
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
57. MOTOR PULLEY AND IDLER PULLEY
ASSEMBLIES
a. Remove front panel. Refer to Paragraph 31,
steps “a’ through “c”.
b. Remove motor and exhaust assembly. Refer to
Paragraph 54, steps “b” through “g”.
c. Refer to Figure 32 for motor and idler pulley
removal.
58. FRONT BULKHEAD ASSEMBLY AND
CYLINDER GLIDES
a. Remove front panel. Refer to Paragraph 31,
steps “a’ through “c”.
b. If present, disconnect cylinder light wires at
connectors.
c. Remove four hex head screws holding
bulkhead to front flange of cabinet and lift
complete bulkhead assembly out of slots in
cabinet. Refer to Figure 33.
d. Remove cylinder glides. Refer to Figure 34.
NOTE: Front air duct will be removed with the
bulkhead unless it had been previously removed in
Paragraph 51.
e. If present, remove two Phillips head screws and
lockwashers holding light receptacle to front
bulkhead. Refer to Figure 23.
TO REMOVE FRONT CYLINDER SEAL
a. Unhook spring from seal strap. Refer to
IMPORTANT: When installing seal, tape it to the
bulkhead in several places to hold in position while
replacing seal strap and spring. Remove tape after
strap and spring are in place. Seal must be under
strap securely and be folded under flanged edge
around entire bulkhead. Strap must be installed
with cupped surface down against the seal to hold
the felt seal more firmly in place on the bulkhead.
Also, the seal can be adhered to the bulkhead using
3M-1300 Sealant (obtain locally). This is
accomplished by applying a bead of 3M-1300
Sealant around the entire flanged area where the
felt seal contacts the bulkhead.
Figure 32
DRY860S
MOTOR STRAP
IDLER
PULLEY
IDLER
LEVER
IDLER
SPRING
MOTOR
PULLEY
GROUND
WIRE
Figure 33
DRY858S
HEX
HEAD
SCREWS
CABINET
ATTACHING
SCREWS
SLOT
HEX
HEAD
SCREWS
