20
53264
Section 5 Service Procedures
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the dryer(s) before servicing.
• Close gas shut-off valve to gas dryer(s) before servicing.
• Never start the dryer(s) with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the dryer is properly grounded.
W001R1
WARNING
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
22. SIGNAL CONTROL
Refer to Figures 8 or 9 for signal control removal.
To Test Signal Control:
1. Remove control panel, and lift assembly off
panel support. Refer to Figures 8 or 9.
2. Disconnect wires from signal control.
NOTE: Refer to appropriate wiring diagram
when rewiring signal control.
3. Set meter to read Ohms and apply probes to
terminals of signal control. Meter should read
approximately 1000 Ohms at all times.
Figure 8
DRY841S
TEMPERATURE
SELECTOR
SWITCH
START
SWITCH
SIGNAL
CONTROL
TIMER
LIGHT
SWITCH
TIMER
ATTACHING
SCREW
CONTROL
PANEL
CONTROL
PANEL
ATTACHING
SCREW
