Allett ELMOW 20, Руководство оператора

Страница: 8 / 43

8
4.0 Preparing to operate
•
Turn the battery isolation key to the OFF (0) position and remove the key.
•
Disconnect the battery charger.
•
Plug the battery pack into the mower power socket.
•
Insert the battery isolation key and turn it to the ON (1) position.
•
Stand behind the mower and grip the handle bars.
5.0 Transport
•
Prepare to operate the mower (refer to the previous section)
•
Switch ON (1) the land roll controller activation switch located on the right
hand panel.
•
Wait for the green light to show continuously (if it does not see trouble
shooting section).
•
With both hands firmly holding the handle bars move the central throttle
control forwards gradually. The mower will move forwards. Increasing the
forward rotation of the throttle control will increase forward speed.
•
To stop return the central throttle control to the neutral position (sprung to
neutral)
•
To reverse, with both hands firmly holding the handle bars move the central
throttle control backwards gradually. The mower will move backwards.
Increasing the backward rotation of the throttle control will increase reversing
speed.
•
To stop return the central throttle control to the neutral position (sprung to
neutral).
Take care when reversing
6.0 Operating the cylinder
•
Prepare to operate the mower (refer to the previous section)
•
Press one or both of the red operator presence controls to the handle bar.
•
Switch ON (1) the cutting cylinder controller activation switch located on the
left hand panel. Move the small red central switch first to unlatch the main
switch for operation. Wait for the green light next to the switch to show
continuously (if it does not see trouble shooting section).
•
The cutting cylinder will start to spin.
•
To stop the cutting cylinder let go of the operator presence handles or turn
OFF (0) the cutting cylinder controller activation switch.
•
To restart the cutting cylinder ensure the cutting cylinder controller activation
switch is in the OFF (0) position. Press one or both the operator presence
control levers to the handle bar and switch ON (1) the cutting cylinder
controller activation switch.
6.1 Back lapping
•
With the battery isolation key removed apply back lapping paste (180 grit) to
the cylinder blades.
•
Adjust the bottom blade so that there is a uniform clearance between the
cylinder blades.
•
Prepare to operate the mower (refer to the previous section)
•
Press one of the red operator presence controls to the handle bar.
•
Press and hold the back lapping switch on the right hand control panel.
•
Switch ON (1) the cutting cylinder controller activation switch located on the
left hand panel. Move the small red central switch first to unlatch the main