9
H>0.50m
C
B
A
Picture 2.6.An example of the connecting with the chimney
In case of fire in the chimney or pipe, immediately turn off the furnace and disconnect it from the mains.
Dismantling and disposing of waste
The packaging consists of materials which are not toxic or harmful. Special conditions for its disposal are not required.
The user is responsible for disposal of the remaining packaging components. He must take the proper disposal procedures
in accordance with the applicable standards in the country where the product is installed.
⚠
ATTENTION: The elements of the packaging must be kept out of the reach of children who are not supervised or
persons with disabilities.
Electric connections
The product may be connected to the mains only after the electrical isolation is installed.
Connect the product to the household power grid.
Just press the main switch on the rear panel if you want to turn on the device. After you do this, the furnace will be
ready for ignition. For the ignition and programming procedures, see Chapter 4.
Room temperature meter
Room temperature meter may be adjusted only after the electric installations have been connected
.
This meter allows the temperature in the room where the furnace is installed to be continuously monitored.
Setting the room temperature meter in a proper position would provide proper operation of the product.
Use of the product
Necessary controls and checks for first ignition
The following instructions have to be observed during first ignition:
•
Check whether all safety requirements have been met (see section 1.8);
•
Connect the device to the power supply only when you are sure that the supply voltage is 230 V 50 Hz. When you
confirm this, change the position of the switch on the back panel to “ON” position;
•
Make sure that the display on the control panel is on, it indicates that the device is properly plugged to the power
supply;
•
Make sure there is enough fuel in the tank for the anticipated period of work.
The fuel must be in accordance with the instructions given in the relevant section of this manual.
Painted parts of the furnace can emit odorous fumes during the first few ignition. This phenomenon is associated with
a chemical stabilisation process in the used paint. For this reason, during this period, the room where the furnace is
located must be regularly and well ventilated.
Fuel feed
Open the upper doors of the product to insert the pellet. With regard to fuel, you must comply with notes contained in
the relevant part of this manual.
⚠
ATTENTION: Do not allow the bag with wooden pellets to come into contact with hot parts of the product during the
fuel feeding.
⚠
ATTENTION: Do not remove the protective mesh within the feeding unit.
⚠
ATTENTION: Do not transfer the full weight of the bag containing the fuel on the product itself.
⚠
ATTENTION: After the feeding of the pellets is completed, close the upper door.
Periodically check the quantity of wood pellets contained in the tank and fill it in time.
⚠
ATTENTION: Excessive moisture can cause the pellet to be crushed into a fine powder which can lead to the
increased sedimentation in the area of the boiler, even to the blockage of the feeding system (auger).
