BOSS – Installation, Operation and Maintenance Manual
A l e n c o n S y s t e m s L L C - P a g e
|
26
Device Target Selection
Select the DCDC/BOSS to command. The targets available are:
1. DCDC GUID’s: Send a command to the individual DCDCs within a BOSS
2. Field Broadcast: Broadcast the command to all the BOSSs in the list i.e. all the GUID’s
will receive the command
Figure 15: Different targets that can be selected
Device Command Selection
The HUB provides a broad set of operational and diagnostic commands. Do not use unlisted
commands unless instructed to do so by Alencon personnel.
Failure to do so may damage the
BOSS and void the warranty.
Customer specific commands –
1. System Reset - Restarts the BOSS and enables Run if in the
Shutdown state.
Note: BOSS will not transition to start or soft pre-charge
without receiving the power direction and the current set
point
2. Shutdown – Disables power production. The BOSS or DCDC
must receive a System Reset command to enable Run.
3. Clear Fault - This command clears all error flags on the target
selected.
Note: It is not necessary to clear faults for the BOSS to
run.
Figure 16: Different Commands for
the BOSS