BOSS – Installation, Operation and Maintenance Manual
A l e n c o n S y s t e m s L L C - P a g e
|
20
BUS & Battery Cable Termination
The BOSS input and output cables have been labelled as BUS and BATT. There are 4
DCDC’s within each BOSS labelled serially as A, B, C, and D. Each DCDC contains a
single input and single output channel.
Since the BOSS is a bi-directional optimizer that can work in both directions, the
connection scheme is flexible i.e.
Safety Note:
After you decide the direction of power flow, please make sure that
input and output cables are connected to their commensurate terminal blocks. Any
interchange will cause a short and possible damage
H4/MC4 Termination:
The termination requires an H4/MC4 crimping tool to mate the connectors
Figure 9: H4/MC4 Crimping
Tool
