30
9.
Cleaning the Note Validator
9.1
OryOne
9.1.1
Cleaning
The ability of acceptance may decrease due to the accumulation of dust and cellulose dust released by
banknotes during transit, or because of residues or sprays, which may spread on the detecting sensors and
on transmission parts. It is therefore recommended that you
clean these parts monthly
, as indicated below.
Turn off the power and unplug the cable from
the 10-pin connector interface.
Press the yellow button C, located
under the reader, to release the main body
from the faceplate, and slide it backwards.
Move the D button upward, hold it while sliding the cover backwards; then lift the latter up and rotate it 180°
rightwards.
Gently wipe the sensors with a clean, lint-free tissue, or with a cotton swab, or with a small sponge, possibly
moistened with isopropyl alcohol.
Completely remove the dust and residues from the 4 silicone rollers, and from the 4 elastic matching wheels
which are located in the lower surface of the upper lid. To remove the most stubborn dirt from rollers and
wheels, use
isopropyl alcohol.
PAY ATTENTION:
use only isopropyle alcohol.
Do not use organic detergents (such as alcohol,
thinners, petrol, a.s.o.).
1.
Sensors
2.
Silicon Dragging Rollers
3.
Elastic matching wheels
After cleaning, it is advisable to calibrate the OryOne by using the Alberici Calibration Card AA-0245 (see
OryOne manual, Chapter 7. Calibration).
WARNING! Do switch power off when
servicing the machine!
C
A
C
B
Содержание LAND
