Albemarle 290 EXPRESS FISHERMAN, Руководство пользователя

Страница: 71 / 134

71
290 XF
The steering helm, accessory switch panel and optional side
mounted engine controls are located on the rear of the helm
console. Binnacle controls and engine ignition or start/
stop switches are mounted on the starboard side of the helm
on the bulkhead. Trim tab switches and the automatic fire
extinguisher monitor and override switch are located on the
helm below the steering wheel.
Molded‑in electronics storage is located forward of the
steering wheel. Access to service the controls and to install
or service electronics is provided through a removable access
panel in the head compartment head liner below the helm.
9.4 Half Tower (Hardtop) and Tower
The half tower and tower consists of a laminated fiberglass
top mounted to a welded aluminum frame that is bolted to the
deck. They can be equipped with spreader lights, courtesy
lights and rod holders. The top and frame is designed to
accommodate radio and GPS antennas, radar antennas and
navigation lights. It could also be equipped with optional
outriggers. Towers are equipped with an operational upper
control station and a sunshade for the upper station.
Electronics antennas must be mounted to the hard top between
the front and rear legs. Antennas mounted on towers may
require extensions if they are mounted on the hard top. There
is a molded in radar antenna mount on the forward part of the
hard top.
Do not mount any antennas or equipment to the brow area
forward of the front legs. The hard top frame is not designed
to support the weight of accessories in this area and could be
damaged. The rear legs are used as the wire chase for lights
and antennas mounted to the hard top.
The warranty for the hard top or tower will be void if the
structure is modified in any way or if heavy accessories like
life rafts are mounted to the top. Additionally, if items like
radar antennas spotlights and other accessories are mounted
in the wrong location, the warranty could be void. If you
intend to add equipment or make modifications to the hard top
or tower, you should contact Albemarle Customer Service to
make sure the equipment you would like to add or the intended
modification will not void the warranty on the fiberglass top
or the aluminum structure.
Because the aluminum frames vary slightly, the side curtains,
front clear connector and drop curtain are custom made to
each boat at the factory. To install the curtains, slide the front
clear connector into the slide track at the front of the top and
snap it to the windshield beginning with the center snaps. The
clear connector will have to be stretched just enough to pull
out the wrinkles to reach the snaps on the windshield.
Helm Access Panel in Head Compartment
Tower
Typical Upper Helm on Tower