Alaxala AX2500S, Руководство по устранению неисправностей

Страница: 64 / 136

3 Troubleshooting Functional Failures During Operation
38
Figure 3-2 Analysis flowchart
If operation cannot be performed correctly or a ring network failure is detected when the
Ring Protocol is used, use the failure analysis method described in the table below to
isolate the cause of the problem for the relevant node in the target ring network.
The analysis method described in the table below applies to AX2500S series switches. For
other AX switch series, see the manuals for the appropriate models.
Table 3-13 Failure analysis method for the Ring Protocol
No. Items to check and commands Action
1 Use the
show axrp
operation
command to check the operating
status of the Ring Protocol.
If
enable
is displayed for
Oper State
, go to No. 2.
If a hyphen ( - ) is displayed for Oper State , required items for
using the Ring Protocol have not been configured. Check the
configuration.
If
disable
is displayed for
Oper State
, the Ring Protocol is
disabled. Check the configuration.
If
Not Operating
is displayed for
Oper State
, the Ring
Protocol functionality is not running. Check the configuration for a
conflict.
2 Use the
show axrp
operation
command to check the operating
mode.
If the operating mode defined in the network configuration is
displayed for
Mode
and
Attribute
, go to No. 3.
If any other information is displayed, check the configuration.
3 Use the
show axrp
operation
command to check the ring port and
its status for each VLAN group.
If the information about the port and status defined in the network
configuration is displayed for
Ring Port
and
Role/State
, go to
No. 4.
If any other information is displayed, check the configuration.