Alaxala AX2500S, Руководство по устранению неисправностей

Страница: 47 / 136

3 Troubleshooting Functional Failures During Operation
21
3.3 Problems occurring while saving files
3.3.1 Information cannot be saved in the startup configuration file
If a problem such as inability to copy information to the startup configuration file by using an
operation command occurs, check the status according to the following table.
Table 3-3 Problems occurring while copying information to the startup configuration file
and action to take
No. Items to check and
commands Items to check
1
Check the response
message to the
command.
If
Can't execute.
is displayed, do the following:
1. Make sure the specified file exists.
2. Make sure the name of the specified file is correct.
3. For all other cases, see No. 2.
2 Try to execute the
format flash
operation
command.
Perform the following procedure:
1.
Use the
format flash
operation command to format the file
system. When
Flash format complete.
indicating successful
formatting is displayed, specify the configuration again, and then
save it to the startup configuration file.
After you execute the
format flash
operation command, all the
previously saved information will be lost. For what information will be
lost, see the description of the
format flash
operation command
in the manual Operation Command Reference .
2. If a message other than
Flash format complete.
is displayed,
the file system might be corrupted.
3.3.2 Copying or writing information to a memory card is not possible
If an operation command-related problem such as inability to copy information to a memory
card occurs, take action according to the following table.
Table 3-4 Problems occurring while copying information to a memory card and action to
take
No. Items to check and
commands Items to check
1 Check the response
message to the
command. Perform the following procedure:
1.
If MC is not inserted. is displayed, no memory card is inserted.
Insert a memory card.
2. If Can't access to MC by write protection. is displayed, the
memory card is write-protected. Remove the memory card, and slide
the write-protect switch (

Lock) in the opposite direction to enable
writing to the memory card.
3. If
No enough space on device.
is displayed, capacity on the
memory card is insufficient. Use the
del
operation command to
delete unnecessary files, and then re-execute the operation.
4. If
Can't execute.
is displayed, see No. 2.
2 Use the
show
ramdisk-file
operation command to
check the file on the
RAMDISK.
Perform the following procedure:
1.
Make sure the specified file exists.
2. Make sure the name of the specified file is correct.
3. If the problem is not resolved by the above two actions, see No. 3.