Airmec CF 1010, Руководство по эксплуатации и техническому обслуживанию

Страница: 27 / 100

MAINTENANCE
fig. 10
fig. 11
compressor for two minutes and then switch
off the motor and check the oil level; if
necessary fill it up again to the centre of
the warning light
CONDENSATION OUTFLOW
Let the condensation flow out after each
working day through the tap under the tank
(fig. 2). It is advisable to supply the tap with
an automatic drainpipe, to guarantee the
full outflow.
SAFETY VALVE
Control the correct functioning of the safety
valve every 2000 hours of operation. Switch
off the compressor when it has reached a
pressure of 6-7 bar and pull the valve ring
C with strength, without getting near with
the face. Compressed air will be released.
If when releasing it, the ring goes back in
normal position and stops the air outlet, the
valve is perfectly working (fig. 11).
If otherwise contact a technician for the
replacement.
V-BELT
The tension of the V-belts is adjusted by the
supplier. When replacing them it is
necessary to make sure that the driving
plates are correctly positioned and adjust
the tension by manipulating the threaded
pin (A), which rises the motor basis and
enables to adjust the belt tension (fig. 12).
CONNECTION TO THE ELECTRIC
INSTALLATION
Make sure that the clamps are fixed when
using the compressor for the first time and
then every six months.
GENERAL MAINTENANCE
Blow compressed air onto the compressor
(within the suggested limits) taking care of
the adjustment devices and the motor.
Remove oil deposits.
fig. 12
GB