SOLO GA | User’s manual
20
FLT Mode indication (HH:MM)
(The picture shows 3 minutes in FLT mode)
FLT and ET modes switch
CHRONO MODE - Elapsed Time (ET)
The ET mode allows a chrono with Minutes and Seconds (until
59:59). The chrono begins to count when you press SET/RST
push button (also when other mode is selected) and returns
to start every time SET/RST is pressed. Can not be stopped,
always is reset to 0 and begins to count automatically.
FLIGHT TIME MODE (FLT)
An internal chrono is started when the device is activated,
and it counts both Hours and Minutes. It always works (in any
mode) while the device is On.
Change between
ADF & ANT mode
In Use Frequency
Stand By Frequency
FRQ Mode
Enables BFO
modulation
Enables FRQ mode
and freqcy transfer
Power
switch
Hundreds and
thousands
selector
Units
selector
7.5 AUTOMATIC DIRECTION FINDER (ADF)
This is 100% functional; the ADF and BFO buttons are working
but perform no actions.
(FS does not allow the user to move
the needle to 90º as would be usual in ANT mode).
Note: NO dash appears when frequency is changed in this
device.
FREQUENCY MODE (FRQ)
In its main mode, it shows two frequencies: Used and Standby.
Distance
meter (NM)
(Nautical Miles)
Speed to the
station (Kt)
(Knobs)
Time to the
station
(Minutes)
Power switch
(OFF – ON)
Source
Selector
