Air-Vac PCBRM100, Руководство пользователя

Страница: 101 / 209

PCBRM100 User’s Guide Chapter 4: Software Overview
4101.00.902 4-63
Park Robot
•
X-Axis / Board Carrier
•
Y-Axis Camera / Z HotGas: A check homes the axis.
•
Y-Axis Solder Pot (back)
•
Y-Axis Solder Pot (front)
Adjust Object Dimensions
•
Use Default Object Size: Unchecked adjusts object dimensions (yellow box) for non-
standard activity. Example: Square flow well against yellow box (flow well below focal
height).
•
Size (X) (mm): (min 0 mm / max 150 mm)
•
Size (Y) (mm): (min 0 mm / max 150 mm)
Skip Next Task: Example: If second pass barrel cleaning not required, as per inspection after first pass
cleaning, skip next event (second pass barrel cleaning)
•
Use Skip Request
•
Skip Message
Restart Event: Primary use is to restart barrel cleaning if a force error occurs (discuss)
•
Allow Restart Event
Nozzle Heating
Z-Axis HotGas – Heater
•
Flow Control (%): (min 0% / max 100%) Gas flow rate for nozzle heater (nozzle size).
•
Use Heater By-Pass Flow: Can be used for component cooling after reflow.
•
Use High-Flow Range: High flow range for large nozzles (adds 3.0 SCFM).
•
Temperature (°C): (min 0 / max 650) Temperature setting for nozzle heater (discuss)
•
Use Stabilize Option: When checked use nozzle heater stabilization routine as per below:
•
Stabilize Channel: When checked (Noz Htr Stblz) use hot gasa head TC.
•
Stabilize Temperature (°C): (min 0 / max 300) Target temp for hot gas head TC
•
Stabilize Range (°C): (min 0 / max 300) Acceptable range (minus/plus)
•
Stabilize Delay (sec): (min 0 / max 1000) Max time before error message