Aimco iEC, Руководство пользователя

Страница: 34 / 48

34
APPENDIX A: Error Codes & Descriptions
Error Code # Fault Description
AUT1
1 TID Timeout Tool ID board communication timeout
32 Tool GND Ground circuit problem between controller and tool
64 Power On Throttle RUN command on during power up
128 Button Timeout Button (run, fwd, rev) communication timeout
256 Button State Illegal button state (example fwd and rev)
512 Undefined Voltage Tool voltage parameter undefined
2048 Tool Update Req ’ d. Tool parameter file is not compatible with controller version
4096 Illegal Tool Tool type is not compatible with controller
CYC1
1 Free Run Timeout Tool has run below threshold level with no load for 5+ seconds
2 Load Run Timeout Tool has run above threshold level for 15+ seconds
4 Hall Error Motor communication signal error
8 Tool Offset Tool cannot reach target torque due to transducer error
64 Tool Level Tool transducer output beyond electrical limits
512 Locked Rotor Motor has stalled for 100+ milliseconds
1024 Drive Fault Motor drive shut down or not responding
EXT1
1 PSet Value Illegal parameter set value
8 TID Param Value Tool ID board communication error
32 TID Param Timeout Tool ID board communication error
4096 Target Value Fault Torque target out of range of tool capabilities
EXT2
1 TID EE Write Communication timeout while writing to tool memory
2 Drive Comm Communication timeout reading / writing to motor drive
4 Vbus Measured controller voltage is not within required limits
8 Drive Update Req Drive firmware not compatible with low speed control
NOTE—Multiple Error Codes will be displayed as the sum of each error code number indicated in
the table above; for example, AUT1: 129 represents AUT1: 128 and AUT1: 1, which would be a
tool ID board timeout and a button timeout