Presto Detacher
™
© 2012 AIC WAIKATO LLC
608-526-6882
39
Rocker Switch Addressing: There is an eight-position rocker switch adjacent to the quality indicator
LED on the Presto detacher circuit board. (See Picture Below) This switch is used to select the
address code needed when hooked to the Herd Tracker II system as a stall identification system.
Each unique switch combination corresponds to the address code as follows: (position 8 is not
used)
SWITCH
1
2
BANK
32 Stalls or less
OFF
OFF
NONE
First 32 Stalls
OFF
ON
A
33 to 64 stalls
ON
OFF
B
65 to 96 stalls
ON
ON
C
Switches one and two are used as switch banks to set-up addresses when the Herd Tracker II is at-
tached to more than 32 units. When 33-64 stalls are hooked to the Herd Tracker the first 32 stalls
are addressed as bank A and the remaining stalls are addressed as bank B. When 65-96 stalls are
hooked to the Herd Tracker the first 32 stalls are addressed as bank A, 33-64 stalls are addressed
Eight Position Addressing Rocker
Switch
Presto Detacher addressing and network termination when hooked-up
Presto PCB Network Addressing
O
F
F
1 2 3 4 5 6 7 8
———————OPEN———————
Each Bank of 32 stalls should be addressed according to the
following switch settings that are listed on the following page:
NOTICE
If the Presto PCB is programmed with version 1.88 or larger, the stall addressing can be
done from Presto front panel, by pushing both switches to enter the set-up, then scroll,
down the set-up menu to use stall addressing switches (NO), next enter parlor size, next
enter stall number. Pressing and holding the right switch will move the stall number in 10’s
