Funktions
connected to
the ALMEMO
®
device directly on the PC
Measuring channel deactivate
yes*
yes (see 3.3)
Meas. channel activate (without range change)
yes*
yes (see 3.3)
D6-range change
no
yes (see 3.3)
V6-function channels use or change
yes*
no
Atm. pressure as a reference for ALMEMO
®
device set
yes*
yes (see 3.3.1)
Atmospheric pressure program on firm value
no
yes (see 3.3.1)
damping program
no
yes (see 3.3.2)
Correction val., zero, slope, base factor program
yes*
yes*
Multi-point calibration
yes**
with factory
calibration
(KA9001DW)
* See the device’s operating instructions and / or the ALMEMO
®
Manual
** with device option KL
3.1 Using the sensor menu
To access and use the sensor menu the ALMEMO
®
Control software should be used
(from V. 5.14.0.330 up). 'Sensor menu' is located in the measuring points list under
'Edit'. Here the four measuring points can be programmed with the special D6 mea -
suring ranges for the D6 sensor and other settings. At the interface the available mea-
suring ranges appear with new easy-to-understand abbreviations, while on the measur-
ing instrument itself only the 'DIGI' range can be used. Not only the range is pro-
grammed but also automatically the units (2 characters) and a comments text; the
channel is then locked at level 5. Ranges can be deleted by selecting '- - - -' in the list.
Function channels
* are determined in the measuring instrument - either as parame-
ters or the result of calculations. They can therefore only be programmed and used by
the device itself. The following function channels are available :
Batt, Mess, Alrm, Diff, Max, Min, M(t), n(t), M(n), Flow, Time
However, if connected directly to the PC, these are not available. The advisory note '!
unusable' will be displayed in the comments text.
Further parameters, depending on sensor type, can be set (e.g. temperature / atmo-
spheric pressure compensation).
Once configuration has been completed the D6 sensor can be connected to any
ALMEMO
®
measuring instrument.
- 7 -
