31
Anaconda
USER MANUAL
5. Slightly dampen a cotton swab with alcohol and gently wipe optical surface. Clean the optical
surface using circular movements, starting from the center and moving out towards the edge.
Do not touch the lens holder. Change the cotton swab after each circular stroke. Repeat until the
optical surface is clean.
6. Clean the battery contact surfaces and contact springs with a pencil eraser and/or alcohol and
cotton swabs.
CAUTION:
Thoroughly dry all items before placing them into the storage/carrying case.
3.2.3 BORE SIGHTING
Perform the Anaconda bore sighting:
— When the Anaconda is mounted to a new weapon for the first time;
— After repair of the Anaconda/ weapon;
— As the need arises (in case of systematic inaccuracy or missing the target).
3.2.4 BATTERY REMOVAL AND REPLACEMENT
Refer to Part 3.1.1 for battery installation procedures.
Replace the remote control battery as follows:
1. Using a screwdriver, unscrew the four screws (A, Figure 3-1) that secure the cover to the bottom
of the unit. Remove the cover.
FIGURE 3-1. WIRELESS REMOTE CONTROL BATTERY INSTALLATION
A
2. Replace the battery with new one (CR2032, 3V). Install the battery, aligning their polarity
markings (+/-) with those embossed on the compartment.
3. Replace the cover and tighten the screws (A).
Содержание ANACONDA Series
Страница 1: ...USER MANUAL ANACONDA THERMAL IMAGING CLIP ON SYSTEM...
Страница 39: ......