16
AGM Global Vision
If the position of the SMS’s clamping nut is uncomfortable, change it as follows:
1. Decide on desirable position of the nut and estimate the angle through which the SMS should be
turned CW (see Figure 2-8).
2. Remove the SMS from the Anaconda.
3. Using a screwdriver, remove the M2×2.5 screws (F, see Figure 2-7) and then unscrew the ring (E).
FIGURE 2-8. ESTIMATION OF THE SMS TURNING ANGLE
NUT
DESIRABLE POSITION
OF THE NUT
CAUTION:
To loosen the ring (E, Figure 2-7), use the two auxiliary non-threaded holes (D). DO NOT
USE the threaded ones.
4. Using a lathe or other precision cutting tool, cut the inside face of the ring (E, Figure 2-7). The
value of cuts (in millimeters) should be equal to the value of the turning angle (in angular
degrees) divided by 360°.
5. Screw the ring (E) into the SMS’s body with its cut end directed inwards. Tighten the screw.
6. After applying a small amount of thread lock to the threads, affix the ring (E) using the two
M2×2.5 screws (F).
2.1.5 INSTALLING THE LIGHT SUPPRESSOR FOR A DAY SCOPE
The Light Suppressor for a Day Scope (A, Figure 2-9) slides over the eyepiece of your daytime
scope (B). The suppressor can be used with scopes that have 40-43 mm eyepiece diameters and
100-120 mm eye relief.
The suppressor can be adjusted for the eye relief of your scope by cutting the rubber at the desired
distance (C).
FIGURE 2-9. LIGHT SUPPRESSOR FOR A DAY SCOPE
A
B
C
Содержание ANACONDA Series
Страница 1: ...USER MANUAL ANACONDA THERMAL IMAGING CLIP ON SYSTEM...
Страница 39: ......