Agilent Technologies SIPS 10, Руководство пользователя

Страница: 29 / 82

Installation
Agilent Sample Introduction Pump System SIPS 10/20 User’s Guide 29
WARNING
Heavy Weight
The SIPS pump unit weighs 5.5 kg (12 lb) and may cause injury or
damage if dropped. Always use care when installing or lifting the pump
unit.
Before installing the electronic control module, check that it is
correctly configured for your Agilent AA instrument. The electronic
control module is shipped from the factory configured for installation
on most Agilent AA instrument instruments (refer to Figure 3).
NOTE
If you are using an Agilent 280FS AA or 140/240 AA
3
, the electronic module is
built into the instrument. If so, you will not need to follow the steps for
installing this module.
To attach the electronic control module to your Agilent AA
instrument, insert the hooks on the mounting plate into the vent slots
on the rear panel of the instrument. Position the module so it does
not cover any of the charts or WARNING information on the rear of
the instrument. The top of the electronic control module should be
level with the upper surface of the instrument.
NOTE
For Agilent 50/55/140/240 AA instruments, which do not have vent slots,
insert the hooks on the mounting plate in the two slots in the rear panel of the
instrument.
3 Factory fitted option