Agilent Technologies N5230-60102, Установочная инструкция

Страница: 14 / 18

14 Installation Note N5230-90004
Step 7. Reinstall the Front Panel Assembly and Install the Front
Panel Jumpers
CAUTION
Before installing the front panel assembly onto the analyzer, lift and support the
front of the analyzer chassis.
Refer to Figure 8 for this procedure. New parts are listed in Table 1 on page 4 .
1. Make sure all 12 of the hex nuts on the front-panel cable connectors have been tightened
using a 5/16-in torque wrench set to 21-in lbs.
2. Reconnect the ribbon cable (item
①
) to the A3 front panel interface board.
3. Slide the front panel over the test port connectors being careful to align the power switch
and floppy disk drive to their corresponding front panel cutouts. Ensure that the ribbon
cable (item
①
) is located below the fan to prevent it from being damaged by the fan blades.
4. With a T-10 TORX driver, install the eight screws (item
②
) in the sides of the frame.
5. Install the six semirigid jumpers (item
③
) on the front panel, and tighten to 10-in lbs.
Figure 8 Front Panel Assembly Reinstallation