Agilent Technologies InfiniiVision 6000 Series, Руководство пользователя, Страница: 64 / 368

64 6000 Series Oscilloscope User’s Guide
2 Front-Panel Controls
7. Probe Compensation Terminals
Use the signal at these
terminals to match each probe’s characteristics to the
oscilloscope channel to which it is connected. See
page 54 .
8. AutoProbe Interface
(Not available on 100 MHz bandwidth
models.) When you connect a probe to the oscilloscope, the
AutoProbe Interface attempts to determine the type of probe
and set its parameters in the Probe menu accordingly. See
page 81 . Note: Although the 100 MHz models lack the AutoProbe
interface, they do have a probe sense ring around the BNC.
Therefore, the probe attenuation factor will be automatically set
when you connect a compatible probe such as the 10073C or
10074C.
9. Channel Input BNC Connector
Attach the oscilloscope probe
or BNC cable to the BNC connector. This is the channel’s input
connector.
10. External Trigger Input
Allows you to trigger the oscilloscope
using an external signal. See page 136 .
11. Trigger Output
This output is related to the oscilloscope’s
internal trigger signal. See page 206 .
12. Calibration Protect Switch
Set this switch to “Protect” to
prevent unwanted re-calibration. See page 105 .
13. 10 MHz Reference Input/Output
You can input a signal,
synchronizing multiple instruments, or you can output this
instrument’s reference signal. See
page 336 .
14. XGA Video Output
You can connect an external display to
the oscilloscope for viewing waveforms. See page 260 .
C A U T I O N
Only connect USB devices to the USB host port. Do not attempt to
connect a host computer to this port to control the oscilloscope. Use
the USB device port if you want to connect a host (see the
InfiniiVision
6000 Series Oscilloscope Programmer’s Quick Start Guide for details).