Agilent Technologies BenchBot, Инструкция по безопасности и установке

Страница: 25 / 72

15
2 Laboratory setup requirements
Workstation table requirements
BenchBot Robot Safety and Installation Guide
Table height
Although the table surface dimensions can vary, the surface must be at least
86 cm (34 in) from the floor. The specified height helps prevent user access
above the Light Curtain or shield.
Figure Minimum distance of the work surface from the floor
Table frame requirements
The table frame must meet the following requirements:
•
The frame must have a leveling mechanism in the feet or castors.
•
The frame and castors should have a minimum load rating of 680 kg
(1500 lb). If you want to use a table with a lower load rating, contact
Automation Solutions Customer Service.
•
The frame must have cross members to prevent the table from swaying
when the workstation is in operation.
•
The frame must have some provisions for securing the table surface.
•
Table legs must be a maximum of 152 cm (60 in) apart.
Table surface requirements
The table surface must meet the following requirements:
•
The table surface must be chemical resistant. (For example, Trespa
®
TopLab
PLUS
®
, phenolic, or equivalent table surfaces have shown to meet
this requirement.) Agilent Technologies does not recommend using
laminated particle board, because the board might be exposed to liquids
around the mounting holes.
•
The table surface must be at least 19 mm (0.75 in) thick.
•
The table surface should permit tapped holes for securing the BenchBot
integration plates. For more information about the integration plates, see
“BenchBot integration plate specifications” on page 18 .
•
The table surface should not overhang the frame by more than 51 mm
(2 in) on each side.
86 cm