Agilent Technologies Agilent E5810A, Руководство пользователя

Страница: 21 / 177

Chapter 1 21
E5810 Description
E5810 Hardware Description
Power-On (Default)
Settings
When power is first applied to the E5810 and the hardware self-test has
completed, the E5810 is initialized to the factory-set default configuration.
This table shows the default configuration parameter settings for the E5810.
The E5810 uses these default configuration values until you set any other
configuration values. The E5810 also uses these values when you press the
Preset
button and hold it down for >10 seconds. See Chapter 3 - Using
E5810 Web Access for a description of each parameter.
Preset
Button
Operation
The
Preset
button on the front panel of the E5810 is used to reset the E5810
to its default configuration values (preset at the factory). As shown in the
figure on the next page, the
Preset
button has two modes of operation:
„
If you depress the
Preset
button and release it in <10 seconds,
only the E5810 password is temporarily changed and is reset to its
default value (E5810). If you cycle power or reboot the E5810, the
E5810 will return to the actual password that was previously set. All
existing configuration values remain unchanged.
„
If you depress and hold the
Preset
button for 10 seconds or more,
all configuration values are reset to their factory default values and
the E5810 is rebooted. All network connections to the E5810,
if any, are also terminated without any cleanups.
Parameter Default Parameter Default
DHCP: ON GPIB Address: 21
IP Address: 169.254.58.10 GPIB Logical Unit: 7
Subnet Mask: 255.255.0.0 RS-232 SICL Interface Name: COM1
Default Gateway: 0.0.0.0 RS-232 Baud Rate: 9600
DNS Server(s): 0.0.0.0 RS-232 Parity: NONE
Hostname: none RS-232 Bits: 8
Description: Agilent E5810
<MAC Addr>
RS-232 Stop Bits: 1
Universal Plug & Play: ON RS-232 Flow Control: NONE
LAN Keepalive (sec): 7200 sec RS-232 SRQ: RI
I/O Timeout (sec): 120 sec Password E5810
GPIB SICL Interface Name: gpib0