132
1260 Infinity Binary LC - System User Guide
6
Appendix
Setting Up a Method using Edit Entire Method
The
Edit Integration Events
screen has two tables:
• Initial Events For All Signals
contains events (integration parameters) that
apply to all signals acquired with the method,
• Specific Events For Signal
contains events which are specific for one type
of detector or specific to different signals from the same detector.
Key parameters in this table are:
•
Slope Sensitivity
represents the slope and curvature of the baseline
needed to mark the start and end of a peak;
•
Peak Width
: the width at half- height of the narrowest peak of interest
should be entered. This helps the integrator to distinguish between
noise and very small peaks;
•
Area Reject / Height Reject
values that control rejection from the results
of peaks whose area or height falls below these values;
•
Integration OFF/ON
suppresses integration between set limits. Almost
always used to inhibit integration in the region from injection to
solvent front or unretained peak marker.
Lines such as
Integration OFF/ON
are added to the table using the icons at
the top of the window.
Click
OK
to exit and the next screen in the Edit Entire Method process
will open.
