Agilent Technologies 35900E Series II, Руководство пользователя

Страница: 33 / 58

Instrument Connection
4
User Manual 33
Digital I/O Connection
Each channel has a 25 pin female connector with 16 signal lines. Of the 16,
eight are bidirectional input/output signals (for such functions as valve
control) and the remaining eight lines are input-only signals (for such
functions as reading bottle-number inputs). A "Y" adaptor cable (
Figure 9 ) is
available to route the 16 digital I/O signals to two 9-pin connectors. This cable
takes the wires from the 8 digital I/O signals in the 25 pin connector and
routes them to the 9 pin female connector labeled "A", and the 8 digital input
only signals and routes them to the 9 pin female connector labeled "B". Use an
instrument-specific cable whenever possible. Use a general purpose cable for
equipment not listed in
Table 9 or Table 10 . Appendix A lists pin assignments
for all open cables.
1
Turn off the power to both the 35900E Series II and the instrument
containing the digital I/O connections.
2
Attach the "Y" adaptor cable's 25 pin connector labeled "C" to the
appropriate channel's digital I/O connector on the rear of the 35900E Series
II.
3
For instrument-specific cables— Connect one end of the cable to the
instrument's digital I/O connector using the instrument manufacturer's
instructions.
For general purpose cables— Use the pin assignments shown in
Appendix A for connector "A" or "B", and follow the instrument
manufacturer's instructions to connect to the instrument's digital I/O.
4
Connect each instrument's digital I/O cables to the "Y" adaptor cable's "A"
and "B" 9 pin female connectors. Note that the "Y" cables "B" connector is for
bottle number type digital input and its "A" connector is for digital I/O used
to control relays.
5
If needed, repeat for the other channel.