Agilent Technologies 34970A, Руководство по обслуживанию, Страница: 41 / 273

To Configure a Measurement Channel
Use this general procedure to configure a measurement channel.
1 Select the channel.
Turn the knob until the desired channel is shown on the right side of
front-panel display. The channel number is a three-digit number;
the left-most digit represents the slot number (
1
00,
2
00, or
3
00) and the
two digits on the right indicate the channel number (1
02
, 1
10
, etc.).
Note:
You can use and to skip to the beginning of the previous
or next slot.
2 Select the measurement parameters for the selected channel.
Use the knob to scroll through the measurement choices on each level
of the menu. When you press
to make your selection, the menu
automatically guides you through all relevant choices to configure a
measurement on the selected function. When you have finished
configuring the parameters, you are automatically exited from the menu.
The present selection (or default) is displayed in full bright for easy
identification. When you make a different selection, the new choice is
shown in full bright and it becomes the default selection. The order of
the choices always remains the same; however, you always enter the
menu at the present (full-bright) setting for each parameter.
Note:
The menu will timeout after about 20 seconds of inactivity and
any changes made previously will take effect.
2
Chapter 2 Quick Start
To Configure a Measurement Channel
39