AGI WHEATHEART X130, Руководство оператора и сборки

Страница: 30 / 46

30 31025 R0
2. Check that all safety decals are installed and legible. Apply new decals if required.
3. Check that no hoses are pinch or being crimped. Re-align as required.
4. Check that all guards are installed and working as intended.
5. Check drive chain tension and alignment. Adjust as required.
• Hopper drive chain — See Section 6.4. – Adjusting the Hopper Drive Chain Tension on page 35
• Wheel drive chain — See Section 6.5. – Adjusting the Wheel Drive Chain Tension on page 37
• Swing auger chain — See Section 6.6. – Swing Auger Chain Tension on page 38
6. Lubricate all grease fittings and oil chains. See Section 6.2. – Lubricate the Equipment on page 32
• Hopper/transition u-joints
• Hopper bearings
• Auger chain drive bearings
• Swing ring u-joint
7. Check hopper winch and lift cable for damage (fraying, kinking and unraveling). Replace as required.
5.4.2 After First Use
1. Check that no hoses are pinched or being crimped. Look for any signs of leaking hydraulic fluid.
2. Check drive chain tension and alignment.
• Hopper drive chain — See Section 6.4. – Adjusting the Hopper Drive Chain Tension on page 35
• Wheel drive chain — See Section 6.5. – Adjusting the Wheel Drive Chain Tension on page 37
• Swing auger chain — See Section 6.6. – Swing Auger Chain Tension on page 38
3. Check hopper winch and lift cable for damage (fraying, kinking and unraveling).
4. Go to the normal servicing and maintenance schedule as defined in the Maintenance section.
5.5. X-Tend Hopper Operation
1. Lower the X-Tend hopper swing from the transport position, tilt the end of the hopper up so that the weight
is on the powerswing tires and place it in the unloading position, roughly perpendicular to the auger.
Note
In regular configurations, it should not be possible to contact the tractor cab by retracting the X-
Tend hopper, however use caution as this can happen when using a right angle PTO drive to operate
your auger.
2. Lower the hopper fully to shift the weight from the powerswing tires onto the hopper tires.
3. Retract the X-Tend hopper all the way.
4. Position the grain truck roughly two feet from the end of the X-Tend hopper, with the X-Tend hopper
centered between the truck hoppers.
5. Extend the X-Tend hopper fully.
6. Tilt/raise the X-Tend hopper up to shift the weight onto the powerswing tires and position it under the
desired truck hopper.
7. Lower/tilt the X-Tend hopper to be flush with the ground when unloading.
5. OPERATION X-TEND HOPPER – X130