AGI WHEATHEART X130, Руководство оператора и сборки

Страница: 23 / 46

31025 R0 23
1. Position the new short truss brace tube between the truss tower and lift arm mount, and secure it with a
1/2" x 1-1/2" bolt and locknut at each end.
Table 5. Replacement Truss Brace Tube
Model Standard Truss Brace Tube
Short Truss Brace Tube
(Replacement)
130-84 10-20078WH 10-21489WH
130-94
130-114 10-20254WH
Figure 6. X130 Short Truss Brace Tube
1
2
3
Table 6. Short Truss Brace Components
Item
Description Part Number
1
X130 Short Truss Brace Tube
10-21489WH
2
Bolt, 1/2" x 1–1/2"
10-19589
3
Locknut, 1/2"
10-19599
4.3.3 Install the Hydraulic Winch
1. Position the hydraulic winch on the winch mounting plate, and secure it using three 3/8" washers and three
3/8" locknuts as shown in Figure 7 on page 24 .
2. Thread the winch cable through the two lift arm pulleys (at the top of the lift arm and at the pulley guide),
then under the spool and connect it to the spool (minimum 3 wraps around the spool, feed cable through
hole in side of spool, and secure with clamp and clamp hardware) as shown in
Figure 8 on page 24 .
3. Connect the hydraulic hoses to the winch, and install pioneer couplings on the hose ends.
4. Thread both hoses through hydraulic hose upper catches on side of auger lower tube and boot. Tighten
hydraulic hose upper catches slightly to hold hoses in place.
X-TEND HOPPER – X130 4. ASSEMBLY